Laser engrave your stuff!

[Zeke]

I found some pics of my mags that were engraved. I love them.

Korean on the Left says Tae Kwon Do
The font on the right is some Counterstrike font.

[Father_Livonia]

Stapo, You might want to mention for them to send you the part they want done rather than the whole gun because im not helping you take apart guns to fit into the laser

here is an example of it on my plastic .45 slide.

[Gestapo]

Ok Guys, Talked with Lutris about pricing last night. After see how much other places charge for laser engraving out there, there will be a flat rate of 15 dollars for 1 logo/picture/whatever. This logo can then be used on any number of items, and then $1.50 cents will be charged per minute of laser time.

[a2nm00gle]

So if I want to get my new Echo1 laser engraved with an Armlite logo, I just ship the gun and the logo?

[Father_Livonia]

Ship the body of the gun, since i will probably be helping stapo and lutris. We dont want to be liable for taking the gun apart to fit into the laser machine.

[a2nm00gle]

I'm not that experienced with airsoft, and I don't want to accidentally screw up my airsoft gun

[Gestapo]

Just take the upper receiver off, and the stock off.

[a2nm00gle]

okay, its just I'm worried about my sheer stupidity. I screw up things alot

[Gestapo]

All you have to do is push the 2 pins out in the body, and the upper receiver slides off. To take the stock off, pull the part that you use to slide the stock back and forth as far down as possible, and pull the stock off. The back plate should be held on by a small screw on the bottom of the stock tube. Unscrew that, take it off. Inside the stock tube at the bottom should be a very long Phillips screw. Take that out, and the stock tube will come off.

[Lutris]

Look. If you want your stuff lasered, email ME. IM ME. Gestapo is NOT the one doing the lasering.
Also, the laser is being used for the current time by the people who actually own it. Laser engraving is on hiatus until further notice. If you REALLY want to send me your ideas to rot in my inbox, my email is [e-mail] and AIM handle is MidwayOtter.

[jdizzle921]

Is the laser engraver still Out of Commission for the general public?? Those pics are sweet!!!!

[Gestapo]

Email Lutris, and he'll let you know.

[jdizzle921]

ok thanks!!!

[airsoftmarine7]

Are you still doing this? I might get a marking on my mags when I get my new m4.

[M.S.-ARC]

airsoftmarine7 you are going to get this one and only warning and if you do not listen to it you will get a ban. Your last two posts (including this one) have been blatant rule violations. I advise you to read all the rules and the stickies before you post again. If you chose to ignore that bit of advice it will continue to be obvious.

Here's your homework. When you are ready to post, the next post I want to see from you is a response on what rules you have violated in your last two posts. If you can't figure that out then you can leave SEMIA.

Here's where you can get started: semiairsoft.proboards45.com/index.cgi?board=rules

EDIT. Now that I've looked more carefully, all your posts have been really bad. I'm now giving you three days to respond so you have until Friday.